| Clamping Element Type RCK 50 |
Clamping Element Type RCK 50
Composed of two conical rings, should always be mounted with a clamping nut. Low torque.
For a shaft with ∅d 24 with a shaft load of less than or equal to 73 Nm should be selected: RCK 50 - 24x28.
N.B. The recommended machining tolerances for the pressure points: up to ∅d 38 mm: shaft h6 - hub H7 over ∅d 40 mm: shaft h8 - hub H8
O u r B r a n d s :
Follow us on: